Westinghouse WSU6603XR Bedienungsanleitung PDF herunterladen (Seite 20)

WATER CONNECTION

WATER INLET HOSE

Connect the appliance to a cold water sup-

ply.

Connect the inlet hose to a water tap with

an external BSP thread spout of 3/4”.

Once connected the inlet hose to the water

tap, turn the tap on and check that there

are no leaks.

Inlet water supply

• Cold water pressure: 800 kPa max - 50

kPa min.

• Water flow rate 10 L / minute min.

• If cold water pressure is in excess of 800

kPa, a pressure reducing valve should be

used. Check for leaks.

Caution! Always use new hoses when

you connect the appliance to the water

mains. Old hoses must not be used.

The water inlet hose must be examined

at an interval of twelve months for

deterioration and replaced if necessary.

The water pressure must be in the limits,

refer to 'Technical data'.

Make sure that the local water authority

gives you the average mains pressure in

your area.

Make sure that the water inlet hose is not

bent or squashed.

Fit the hose nut correctly to prevent water

leaks.

Caution! Do not connect the appliance

to new pipes or pipes that have been

not used for a long time. Let the water

run for some minutes, then connect the

inlet hose.

The water inlet hose is double-walled and

has an inner mains cable and a safety valve.

The water inlet hose is under pressure only

while the water is running. If there is a leak

in the water inlet hose, , the safety valve in-

terrupts the running water.

Be careful when you install the water inlet

hose.

Warning!

• The mains cable is in the double-

walled inlet hose. Do not immerse

the water inlet hose or the safety

valve in water.

• Do not attempt to shorten the inlet

hose.

• If the water inlet hose or the safety

valve is damaged, immediately turn

off the power and remove the mains

plug from the mains socket.

• Only a qualified Service Engineer can

replace the water inlet hose with

safety valve.

Warning! Dangerous voltage

WATER DRAIN HOSE

Use the supplied hose clamp to connect

the water drain hose to the sink.

The highest point of the drain hose must be

no more than 600 mm from the floor and

must have a continuous fall to the plumbing

connection.

The drain hose can be lengthened using

additional lengths and connectors. These

must be purchased from Electrolux Spare

Parts. The extension length must not ex-

ceed 2 metres.

The drain hose must be free of obstruc-

tions.

Remove the sink plug when the appliance

drains the water to prevent that the water

goes back into the appliance.

If you connect the water drain hose to a

trap spigot under the sink, remove the plas-

tic membrane. If you do not remove the

membrane, remaining food can cause a

blockage in the drain hose spigot

20 westinghouse

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare